Maxview MXL020HD Especificações descarregar pdf (Página 23)

Antenna Setup

Instruction for the presetting “ﬁxed antenna”

> Satellite: Satellite selection. Here, all satellites enabled in the submenu “Satellite list” are

listed. Select the satellite to be edited.

> LNB Frequency: Set the corresponding LNB frequency for the selected satellite. The

default setting is universal.

If you connect your receiver to a single cable system, you must set the selection one cable.

The detailed explanation for connection to a cable system can be found below.

Now you have to select the following points:

• IF-Channel • Centre Frequency • Satellite position

The values to be set mainly depend on the one cable system. Follow the indications in the

operating manual of the one cable system.

Please note: Assign the receiver number (= IF-Channel) and ZF-Frequency

(Centre Freq) only once and in pairs.

> Transponder: List of the programmed transponders.

> DiSEqC1.0: Setting for multi-satellite reception.

> DiSEqC1.1: Setting for multi-satellite reception.

> 22K: Will be set automatically by the receiver.

> Polarity: The default setting is “AUTO”. However, you can dene the horizontal or

vertical LNB supply voltage.

Page 23

MXL020HD INSTRUCTIONS REVISION.indd 23 15/05/2013 14:12

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Sem comentários

Maxview MXL020HD Especificações Página 23